Power Fist 10 in. Bench-Top Drill Press, Руководство пользователя

Страница: 11 / 40

V 4.0 10 in. Bench-Top Drill Press 8654337
d. Slide the Height Crank (#23) over the Shaft (#24) on the side of the
Table Support (#21). Secure it to the Shaft using the Screw (#22)
against the flat part of the Shaft.
3. Headstock to Column.
a. Loosen the two Set Screws (#17) on the left side of the Headstock
(#67) so they will stay clear while installing it.
b. With the help of an assistant, lift the Headstock above the Column
(#6) and gently slide it down the Column as far as it will go.
c. Tighten the two Set Screws to secure the Headstock in place.
4. Feed Handles / Bars.
a. Thread the Feed Bars (#9) into the Feed Bar Seat (#10) and tighten them.
5. Installing the Chuck.
a. Thoroughly clean the Arbor (#30) and the tapered hole in the Chuck
(#29) of all dirt, grease, oil and protective coatings. Make sure all
parts are thoroughly clean, dry and burr free.
b. Insert the Arbor into the end of the Spindle (#31). If necessary, rotate
the Arbor to ensure that it is correctly positioned and fully inserted
into the Spindle shaft. Firmly tap the Arbor nose with a rubber mallet.
c. Open the jaws of the Chuck to their maximum, using the supplied Chuck Key.
d. Slide the Chuck onto the Arbor nose as far as it will go.
e. Hold a piece of scrap wood against the Chuck nose to protect it and
firmly tap the wood with a rubber mallet to ensure proper seating and
a solid fit of the Chuck on the Spindle.
OPERATION
TOOL SET UP
WARNING! To prevent serious injury from accidental operation. Turn the
Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Visit www.princessauto.com for more information 11