Power Fist 10 in. Bench-Top Drill Press, Руководство пользователя

Страница: 12 / 40

8654337 10 in. Bench-Top Drill Press V 4.0
TABLE ADJUSTMENT
1.
Raise or lower the Table by loosening the Pivot Lever (#20) and turning the
Height Crank (#23), clockwise to raise and counterclockwise to lower.
2.
Pivot the Table (#26) around the Column (#6) by loosening the Pivot Lever
(#20). The entire Table assembly and Rack (#7), will move as one around
the Column.
3.
Tilt the Table by loosening the Angle Bolt (#28) and tilting to the required
angle. The angle can be read using the Angle Scale (#25).
4. T
o ensure that the drill is entirely perpendicular to the table, insert a straight
round bar (not included) in the chuck (#29), place a square on the Table
(#26) and bring it up to the round bar. Adjust the angle as needed.
5. Make sure the table height and position is set so that the drill travel range
is sufficient for the material to be drilled.
IMPORTANT! To prevent injury from unexpected Table movement, tighten the
Angle Bolt (#28) and Pivot Lever (#20) after adjustment.
SET DRILLING DEPTH
Located around the Spindle Feed Shaft is a Depth Stop Collar with a scale. The collar
is capable of turning about the shaft and may be locked in place by a Locking Screw.
1.
Lower the drill (with the power OFF) so that it contacts the material and
hold in that position.
2.
Loosen the locking screw and turn the collar so that the measurement for
the depth of the hole required is in line with the pointer.
3.
Lock the collar in this position using the locking screw.
CHANGING DRILL SPEED
Before changing the speeds, make sure the machine is switched off and unplugged.
1.
Open the pulley cover.
2.
Loosen the Motor Tension Knob (#70) on each side of the Headstock (#67)
and move the Motor (#77) towards the Headstock to relieve tension on the
Belts (#43, 80).
3.
Consult the chart below and position the Belts (#43, 80) on the Pulleys
(#42, 46, 78) according to the desired drill speed.
12 For technical questions call 1-800-665-8685