Power Electronics SD700FL Series, Руководство по аппаратному обеспечению и установке

Страница: 20 / 95

SD700FL SERIES
POWER ELECTRONICS
18
RECEPTION, HANDLING AND TRANSPORTATION
4. RECEPTION, HANDLING AND
TRANSPORTATION
CAUTION
Read carefully the following instructions for a correct handling.
Otherwise, it could lead to people injury and cause damaged to the equipment .
4.1. Reception and Storage
The SD700FL is carefully tested and perfectly packed before delivering. In the event of transport
damage, please ensure that you notify the transport agency and Power Electronics: 902 40 20 70
(Interna34 96 136 65 57) or your nearest agent, within 24hrs from receipt of the goods.
Make sure model and serial number of the drive are the same on the delivery note and unit. Check that
the following documentation is attached:
- SD700FL Hardware and Installation Manual.
- General documentation CD including software and programming manual.
Drive
‟s storage should be sun and moisture protected and with an ambient temperature between
-40°C and +70°C, < 95 RH without condensation. It is recommended not pile more than two units.
4.2. Handling and Transportation
Only the transport methods described in this document or in the delivery notes are permissible. Any other
transport method or system could damage the unit.
In the case of SD700FL Frame 1, the drive and the filter are delivered separately, horizontally in two
cardboard boxes.
In the case of SD700FL Frames 2 to 4, the drive and the filter are delivered separately, horizontally,
fastened to a wooden pallet and covered with a wooden box.
Depending on the mean of transport, SD700FL frames 5 to 11 is delivered horizontally or vertically.
When the transport is by land, the SD700FL is delivered vertically, fastened to a wooden pallet and
covered with a cardboard box. When the transport is by air, the SD700FL is delivered horizontally,
fastened to a wooden pallet and covered with a wooden box. When the SD700FL is built-in more than 5
filter modules, the filter modules will be delivered separately from the drive.
Depending on the transport method, the drive could be moisture protected with a vacuum plastic bag.
Move the complete pallet as close as possible to its final installation place before unpacking, to avoid any
damage during transportation.
It is mandatory to transport it with a pallet truck, forklift or crane fork, taking care about the load
distribution and centre of gravity. Check the size and weight of the equipment to choose proper lifting
equipment with a capacity greater than the drive weight.
Unpack the drive carefully. Do not use edge tool to protect the product from damage. After open the
package, please check the goods contained. Verify the item numbers contained within the package with
the packing inventory list. Please set aside and reserve, if contained, the case of spare parts shipped
with the product. There should be no evident damage caused by vibration, dropping or moisture.
CAUTION
If the maximum tonnage of cranes cannot meet the requirement,
it could lead to people injury and
cause damage to the equipment.