Installation and Operating Instructions PBX-200 PB / Li
page 16
The figure below shows how
two Power-Blox can be
coupled together.
Before the two units are
coupled, switch off both units.
The transfer cable (9) of the
upper unit is now passed
through the cable guide
channel (10) and connected to
one of the two transfer
sockets (6) of the lower unit. It
does not matter which of the
two transfer sockets (6) is
used.
After switching on the two
Power-Blox both Power-Blox
synchronize and form a
"swarm net".
Up to three Power-Blox can
be connected to a tower and
several towers can be coupled
to each other.
Figure 8: Two coupled Power-Blox as a power tower
DANGER!
Do not form any towers that are higher than three units. Each Power-Blox weighs 52kg
and a tall tower could fall over and hurt you. Higher towers are unstable and can easily
tilt if they are not properly fixed or on a bad ground.
The resulting tower is provided at the sockets outlet (1) the power of all Power-Blox in the tower.
If you want to create larger mini-grids, go to chapter 7.8.3.
