8
WARNING:
The operator or others
must not try to clear away cut material with the
engine running or the blade turning to avoid seri-
ous injury. Stop engine and blade before remov-
ing materials wrapped around blade or shaft.
MAINTENANCE
WARNING:
Always stop unit and dis-
connect spark plug wire before performing
maintenance.
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts.
S
Blade Shield -- Discontinue use of brushcut-
ter attachment if shield is damaged.
CHECK FOR LOOSE FASTENERS
AND PARTS
S
Blade nut
S
Fasteners
INSPECT AND CLEAN UNIT
AND DECALS
S
After each use, inspect complete unit for loose
or damaged parts. Clean the unit and decals
using a damp cloth with a mild detergent.
S
Wipe off unit with a clean dry cloth.
BLADE MAINTENANCE
WARNING:
The blade will continue to
spin after the engine stops or after the throttle
trigger has been released. To avoid serious
injury, make sure the blade has stopped
coasting and disconnect the spark plug before
performing work on the blade.
WARNING:
Always replace a blade
that is bent, warped, cracked, broken, or dam-
aged in any other way. Never attempt to
straighten and reuse a damaged blade. Use
only specified replacement blade. Wear pro-
tective gloves when handling or performing
maintenance on the blade to help avoid injury.
S
Check blade for flatness periodically. Lay
the blade on a flat surface to inspect for flat-
ness. Throw away a blade that is not flat.
SERVICE AND ADJUSTMENTS
BLADE REPLACEMENT
WARNING:
The blade will continue to
spin after the engine stops or after the throttle
trigger has been released. To avoid serious
injury, make sure the blade has stopped
coasting and disconnect the spark plug before
performing work on the blade.
WARNING:
Wear protective gloves
when handling or performing maintenance on
the blade to avoid injury. The blade is sharp and
can cut you even when it is not moving.
1. To remove the blade, align hole in the dust
cup with the hole in the side of the gear-
box by rotating the blade.
2. Insert a small screwdriver into aligned
holes. This will keep the shaft from turn-
ing while loosening the blade nut.
Screwdriver
3. While holding the screwdriver in position,
remove blade nut by turning clockwise as
you are facing the nut.
4. Remove both washers and the blade
from the blade shaft. Leave the dust cup
on the gearbox.
5. Install new blade and retaining washer onto
the threaded shaft extending from the gear-
box (blade must be between the dust cup
and the retaining washer). Make sure the
raised part of the retaining washer is facing
the gearbox, and the raised area fits into the
hole in the center of the blade.
Shield
Blade
Retaining
Washer
Dust Cup
Cupped
Washer
Nut
Threaded Shaft
Gearbox
