Poulan Pro PL1416, Инструкция по эксплуатации

Страница: 12 / 36

MAINTENANCE
a
WARNING: Unplug the power tool from the power
source before performing maintenance. Severe
injury or death could occur from electrical shock
or body contact with moving parts.
a
WARNING: The cutting edges on the chain are
sharp. Use protective gloves when handling the
chain.
GUIDE BAR MAINTENANCE
&RQGLWLRQVZKLFKUHTXLUHJXLGHEDUPDLQWHQDQFH
• The chain saw cuts to one side or at an angle.
• The chain saw has to be forced through the cut.
• There is an inadequate supply of oil to the guide bar
and chain.
Cleaning the guide bar rails
The rails that hold the chain in place should be cleaned if
the guide bar or chain appear to be dirty.
The rails should also be cleaned every time the chain is
removed.
1. Remove the sprocket cover, guide bar and chain.
2. Use a wire brush, screwdriver or similar tool to clear
the residue from the inner groove of the guide bar.
3. Clean the oil passages thoroughly.
Filing the guide bar rails
:KHQUDLOWRSLVXQHYHQXVHDÀDW¿OHWRUHVWRUHVTXDUH
edges and sides.
A B
A = Worn Groove
B = Correct Groove
Replace the guide bar when the groove is worn, the guide
bar is bent or cracked, or when excess heating or burring
of the rails occurs. Only use a replacement guide bar that
matches the original guide bar.
Turning the guide bar
The guide bar is subjected to especially severe wear and
tear at the nose and the bottom. To avoid one-sided wear
and tear, turn the guide bar over every time when you
sharpen the chain.
CHAIN MAINTENANCE
&RQGLWLRQVZKLFKUHTXLUHFKDLQPDLQWHQDQFH
• The chain saw cuts to one side or at an angle.
• The chain saw has to be forced through the cut.
Keep the chain sharp. A properly sharpened chain will cut
faster and more safely. A dull chain will cause sprocket,
guide bar, and motor wear.
If you must force the chain into the wood and cutting
creates only sawdust with few large chips, the chain is
dull.
<RXFDQKDYH\RXUFKDLQVKDUSHQHGE\VSHFLDOLVWGHDOHUV
or obtain chain sharpening equipment to enable you
to sharpen the chain yourself. Follow the operating
instructions provided with the sharpening equipment.
Replace the chain when the cutters are too worn to
sharpen. Only use a replacement chain that matches the
original chain.
TROUBLESHOOTING
a
WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
TROUBLE CAUSE REMEDY
Chain saw fails to operate 1. No power
2. Faulty wall outlet
3. Extension cord damaged
4. Circuit breaker shut off or faulty
5. Chain brake activated (if
equipped)
1. Check power
2. Use another outlet
3. Check cord, replace
4. Reset or replace circuit breaker
5. Reset the chain brake (if equipped)
Chain saw operates intermittently 1. Extension cord damaged
2. Loose internal connection
3. Internal wiring defective
4. Trigger defective 1. Check cord, replace
2. Call an authorized service center.
3. Call an authorized service center.
4. Call an authorized service center.
Dry chain 1. No oil in reservoir
2. Oil passage clogged 1.
5H¿OORLO
2. Clean oil passage outlet
12