Pottinger EUROHIT 58 N, Руководство по эксплуатации

Страница: 6 / 29

Cleaning of machine parts
Attention ! Do not use high-pressure washers for the
cleaning of bearing- and hydraulic parts.
- Danger of rust!
- After cleaning, grease the machine according to the
lubrication chart and carry out a short test run.
- Cleaning with too high pressure may do damage to
varnish.
Parking in the
open
When parking for longer
periods in the open, clean
plunger rods and then coat
with grease.
Check when parking
• So that rain water can run off
unhindered, the holes " W" must
not be blocked.
Winter storage
- Thoroughly clean machine before storage.
- Put up protection against weather.
- Protect exposed parts from rust.
- Lubricate all greasing points according to lubrication
chart.
- Park machine with
liftet rotors, which will
protect plunger from
rust.
TD32/90/12
A
E
60 TD12/93/13
A
E1 E2
FETT
TD49/93/2
W
TD7/95/5
Lowering the rotary tedder
The machine can be lowered both from the working position and from
the transport position.
Danger of tipping
Park the machine on firm, level ground.
If the ground is soft then the area where the support foot is to
stand must be appropriately increased using a suitable aid
(e.g. wooden board).
- Unpin bolt on the slewing headstock (SB) in position A.
Important!
Only reposition bolts when the machine is in the raised position.
- Lower the machine with the tractor hydraulic system and place on
support foot.
- Pull off drive shaft and rest on support.
Do not rest drive shaft on safety chain!
- Close stopcock (position A).
- Unhitch machine from tractor.
- Remove hydraulic cables.
TD9/92/14
10
- 6 -
LOWERING THE MACHINE
9500 GB ABSTELLEN (209)
GB