(358) ALLG. WARTUNG 0000-GB
- 15 -
MAINTENANCE
GB
Safety points
• Turn engine off when adjustment,
service and repair work is to be
done.
• Do not work under the machine
without safe support.
• Retighten all screws after the first
hours of operation.
General maintenance hints
In order to keep the implement in good condition after
long periods of operation, please observe the following
points:
- Tighten all screws after the first hours of operation.
Check blade screws in particular.
- Observe maintenance hints for angular gear and
cutter bar.
Spare parts
a. The original components and accessories have been designed
especially for these machines and appliances.
b. We want to make it quite clear that components and accesories that have
not been supplied by us have not been tested by us.
c. The installation and/or use of such products can, therefore, negatively
change or influence the construction characteristics of the appliance. We
are not liable for damages caused by the use of components and
accessories that have not been supplied by us.
d. Alterations and the use of auxiliary parts that are not permitted by the
manufacturer render all liability invalid.
Repair Instructions
Please refer to repair instructions in supplement
Cleaning of machine parts
Attention! Do not use high-pressure
washers for the
cleaning of bearing-
and hydraulic parts.
- Danger of rust!
- After cleaning, grease
the machine according
to the lubrication chart
and carry out a short test run.
- Cleaning with too high pressure may do
damage to varnish.
Parking in the open
When parking in the open for
long periods of time, clean
piston rods and then coat with
grease.
Winter storage
- Thoroughly clean machine before storage.
- Put up protection against weather.
- Change or replenish gear oil.
- Protect exposed parts from rust.
- Lubricate all greasing points according to lubrication chart.
Drive shafts
- see supplement
Hydraulic unit
Caution! Danger of injury or infection!
Under high pressure, escaping fluids can penetrate the skin.
Therefore seek immediate medical help!
After the first 10 operating hours and then every
consecutive 50 operating hours
- Check the hydraulic unit and lines for tightness and retighten
screw connections if necessary.
Before operation
- Check hydraulic hoses for wear.
Replace worn or damaged hydraulic hoses immediately. The
replacement hoses must meet the manufacturer’s technical
requirements.
FETT
TD49/93/2
