Page 4/ 6
5. Roll out the 2 Slat Roll (D) onto the slat support rail of the Side Rails (C) as seen in the illustration below.
6. Secure the slat rolls with 64 Wood Screws (I) using a Phillips Head Screwdriver (not included).
Assembly Instructions (High position):
7. The bed is assembled in the low position when shipped. If you wish to use it without the box spring, follow the
instructions below.
a. Move the
extra
mattress support
rail
found on the bottom of
the side rail up by removing the Allen
Bolts and Washers that were pre installed using the Allen Key (H) by rotating counterclockwise as
seen in the illustration below.
b. Fasten the mattress support to the holes found at the top of the Side Rail (C) by aligning the bolts
with washers and rotate clockwise to tighten using the Allen Key (H).