Page 10/ 10
Note: The Headboard is designed to attach the box spring frame (sold separately). Use the hardware
supplied with the Headboard to attach the box spring frame. Pre assembled the box frame first. Make sure
the face plate of the box frame is set at high position.
1. Hold the Headboard (A) upright and tilt slightly towards the faceplates of the pre assembled bed frame.
2. Align the slots of the faceplates with the pre-drilled holes of the headboard, as seen below. If the holes do not
align perfectly, adjust the levelers underneath the legs by lifting the Headboard slightly to provide access to the
leveler. Turn the leveler until the alignment has been reach.
3. Insert the Allen Bolts (J) through the Spring Washers (I), Flat Washers (H), and faceplate slots into the pre-drilled
holes of Headboard, as seen in the illustration below.
4.
Tighten using the supplied Allen Key (L). Keep the extra hardware for future use.
Low Position
High Position
20.
Assembly is complete.
Care Instructions:
Dust often using a clean, soft, dry, and lint-free cloth.
Blot spills immediately and wipe with a clean, damp cloth.
We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-tighten if
necessary.
Thank you for your purchase
Stores | catalog | www.potterybarn.com
