Posligne ODP 200, Техническое руководство

Страница: 83 / 84

ODP 200 Technical Manual
83
Hex 1C 53
n1 n2
Decimal 28 83 n1 n2
[Range]
0
≤
n1
≤
255
0
≤
n2
≤
255
[Description]
Sets left- and right-side Kanji character spacing
n1
and
n2
, respectively.
When the printer model used supports GS P , the left-side character spacing is [
n1
x horizontal or
vertical motion units], and the right-side character spacing is [
n2
x horizontal or vertical motion
units].
[Notes]
When double-width mode is set, the left- and right-side character spacing is twice the normal
value.
The horizontal and vertical motion units are set by GS P . The previously specified character
spacing does not change, even if the horizontal or vertical motion unit is changed using
GS P
.
The value cannot be less than the minimum horizontal movement amount, and must be in even
units of the minimum horizontal movement amount.
In standard mode, the horizontal motion unit is used.
In page mode, the horizontal or vertical motion unit differs in page mode, depending on starting
position of the printable area as follow:
①
When the starting position is set to the upper left or lower right of the printable area using
ESC T, the horizontal motion unit (
x
) is used.
②
When the starting position is set to the upper right or lower left of the printable area using
ESC T, the vertical motion unit (
y
) is used.
③
The maximum right-side spacing is 255/180 inches for the paper roll and is approximately
35.983 mm{255/150 inches}. Any setting exceeding the maximum is converted to the
maximum automatically.
[Default]
n1
= 0,
n2
= 0
[Reference]
GS P
FS W n
[Name]
Turn quadruple-size mode on/off for Kanji characters
[Format]
ASCII FS W
n
Hex 1C 57
n
Decimal 28 87
n
[Range] 0
≤
n
≤
255
[Description]
Turns quadruple-size mode on or off for Kanji characters.
When the LSB of
n
is 0, quadruple-size mode for Kanji characters is turned off.
When the LSB of
n
is 1, quadruple-size mode for Kanji characters is turned on.
[Notes]
Only the lowest bit of
n
is valid.
In quadruple-size mode, the printer prints the same size characters as when double-width and
doubled-height modes are both turned on.
When quadruple-size mode is turned off using this command, the following characters are
printed in normal size.
When some of the characters on a line are different in height, all the characters on the line are
aligned at the baseline.