Positron 3782651U/50, Руководство пользователя

Страница: 44 / 60

Using the Insulator Tester & Software
40
5.4 Important General Notes

Always use the same Bluetooth adapter with its paired Tablet/Laptop.

If the Probe has not been used for more than six (6) months, recharge its Ni-Cad battery
before switching ON the power of the Probe.

The Probe’s battery should be recharged overnight (9 hours minimum) before each day of
testing. If the power switch remains ON, the battery will discharge completely after two
days.

Recharge the battery of the Probe and the Tablet/Laptop before a day of testing.

Switch the power OFF when the Probe is left unused. To switch the Probe OFF, remove the
cover and move the slide switch away from the RS232 connector.

To verify that the power is ON, press the push-button; the LED should flash, then press the
push-button again to switch the light OFF.

Do not use the Probe and the Tablet/Laptop in rain or snow.

To recharge the battery, remove the RS232 cover (3” x 1”), plug the charger cable to the
Probe and plug the universal wall transformer to a 120/220 Vac source, 50 or 60 Hz.

If the battery is completely discharged (No light on power-up), switch the Probe OFF while
the battery is recharging. Under normal circumstances, it is not necessary to switch the
Probe OFF during a recharge.
Switching the Probe OFF will erase all data in the Probe.
The equipment covered in this manual should be used and serviced only by competent and
trained personnel familiar with and following good work safety practices. This equipment is
intended solely for the use by such trained personnel. This manual is not intended as a
substitute for adequate training and experience. Appropriate safety procedures must be
followed at all times in the use of this equipment.
This equipment will not detect any non-conductive defects including non-conducting
mechanical defects.
N
OTE
N
OTE
WARNING