Positive Grid BIAS MODULATION, Руководство по эксплуатации продукта

Страница: 7 / 32

11 12
FUNCTION AND OPERATION
2. Engage & Bypass
When you first plug the power in, BIAS Modulation pedal will be in
Bypass Mode
, meaning
that the input signal will be passed through the pedal without any modification from the
presets’ processing. There are two different bypass types for BIAS Modulation:
A. Buffer Bypass (System default) -
The signal will go through the buffer circuit and generate a
lower-impedance output signal. This allows the output signal to go through a much longer
cable without compromising high frequencies. In addition, Buffer Bypass can prevent the
common ‘pop’ noise you’d otherwise hear when engaging or disengaging a preset.
B. True Bypass -
This creates a short circuit between the input and output to keep the
bypassed signal untouched as a high-impedance output signal. If you are using a cable
longer than 18.5 feet while using this bypass mode, you might get volume loss in the high
frequencies.
To engage a preset and hear its effect, press one of the A, B or C footswitches. Press the
same footswitch again to switch back to bypass mode, or press another footswitch to switch to
another preset.
1. Mono & Stereo
BIAS Modulation comes with stereo inputs and outputs. With mono input (plugging into the left
channel only), BIAS Modulation will duplicate the input signal on both channels so you can still
get stereo signal at BIAS Modulation’s outputs. This is necessary in order to hear some of
BIAS Modulation’s stereo effects panned properly. If you also plug into the pedal’s right input,
BIAS Delay will switch to stereo mode and process left and right channels independently.
3. Save Preset
Once the preset is on, you can tweak any of the knobs on the control panel to modify its
sound. The preset LED will start to blink when you move a knob, indicating that the parameter
has changed.
1. hold the preset knob
2. LED stop blinking
Preset ON 1. tweak of the knob
2. LED start to blink
To save the parameter changes, hold the preset knob until
the LED stops blinking.
To dismiss the changes, switch to another preset or switch
back to Bypass Mode.