POSIFLEX PD-30 UE Series, Руководство пользователя

Страница: 10 / 16

Page 10
Please always keep a gentle pressure at the
bottom end of pole base (bottom locking lugs
A’
)
to the left (away from the sidewall of system
chassis) when moving the upper part of pole
toward sidewall as in the left picture.
6. Please refer to the right picture taken from inside
of HT or PB system to show that the 2 short
cylindrical locating bosses
B’
should match into
2 round holes
B
in the I/O plate. The bosses B’ inside holes B
are shown in the enlarged portion.
7. Please note the importance of keeping the leftward pressure on bottom
end of pole display during the process of turning the pole upright and
inserting the locating bosses
B’ or even when you want to release the
locating bosses B’ away from I/O plate B and turn the upper end of pole
display to the left to remove the
locking lugs
A’
from bottom chassis
A . Ignorance of this point may
damage or even break off the locking
lugs
A’
due to improper torque
applied.
8. The screw bosses on base of PD-
307UE should now align with the
screw holes on sidewall of system chassis. Only 1 screw needs to be
applied. Use the self-tapping screw that comes with PD-307UE to fix
from external side of sidewall as demonstrated in the right picture.
9. Carefully close back the top cover of HT or PB system and connect the
interface cable of PD-307UE to appropriate port in system connector area.
Then close the back cover of the system.
PD-305UE, PD-306UE for KS or TP series:
1. Remove rear connect cover of the KS or
TP series terminal system from the base
per instruction of the terminal system.
2. Have the cable of PD-305UE, PD-306UE that comes
A’
Outside of sidewall
PD-307 Base
Pix. 6
C+C’
Cable Exit
B+B’
B+B’