POSIFLEX PD-30 UE Series, Руководство пользователя

Страница: 12 / 16

Page 12
For PD-300UE model:
The RJ45 type modular connector is for VFD display purpose and also already
occupied. Connect the “B” type plug of the interface cable to the base USB
connector and the “A” type end to USB port of the host. Insert the DC plug of
12V DC power adaptor to the “12V DC IN” jack in the pole base.
You may now place the base on a horizontal surface and prepare to power on
and adjust the direction of the display head for best viewing effect in
application.
COMMAND EMULATION MODE SETUP
(FOR PD-300UE series)
Now please check the back of PD-300UE series display head as in the picture
below. There is a small piece of plastic cover for the “DIP switch window”.
Slide the cover downward but don’t pull it off otherwise you may have to
practice for inserting it back. You can find 4 positions of DIP switches in this
window. Adjust for the appropriate interface used by the DIP switch according
to below table. Switch position counts from left to right and “ON” means
pushed up as indicated in the below picture below.
Switch Position
1 2 3 4
Interface
ON ON OFF OFF USB Vendor Class
ON OFF OFF OFF USB HID Class
OFF ON OFF OFF Reserved
OFF OFF OFF OFF Virtual COM Port
The factory default command mode is set to Epson mode for normal
delivery. Please change it to Epson mode if OPOS or UPOS driver is used for
DIP
switch
window
DC
B-Type USB Port To Display Head