POSIFLEX PD-30 UE Series, Руководство пользователя

Страница: 11 / 16

Page 11
out of its base joint to enter the base of host system
through the cable exit to connect to the main unit.
3. Match the base joint of PD-305UE or PD-306UE to the system rear
connect area. Fit 2 screws
through washers at arrowed points in the right
pictures to hold the joint tight.
PD-303UE:
1. Adhere the two pieces of EVA tape on the metal plates at bottom as
indicated in picture at right. Peel off the protective covers of the tape to
stick PD303UE series on a flat and clean
surface.
2. Apply the screws at 2 arrows in the right
picture for firm fixation on counter if
necessary.
PD-302UE for TP series:
1. Aim the bottom center cavity of PD302UE series
toward the latch stub at rear of TP series main unit as
circled in the right picture. Then aim both metal and
plastic hooks at rear of the PD302UE series toward
the suitable ventilation openings on top rear of the
main unit. Please use a Phillips head (“+” sign) screw
driver to fasten the screws on the metal hook but not
to overdo it so that the metal hooks hold the ribs of the ventilation holes
from inside.
2. Plug the other USB end of PD-302UE at the USB connector of TP.
3. Route the cable to go through the notch on back of the stand assembly of
touch terminal as indicated in the picture. Reassemble the main unit and
stand assembly.
(
Guidance for future un-installation:
Please use
screw driver to release the metal hook before
removing PD302UE from the ventilation holes.)
PD-300UE:
In base of stand alone models, looking from rear side of the bottom, the
connector area will look like below:
PD-305UE
PD-306UE
Metal Hook
Plastic Hook