Part 8
When the printer is used as a kitchen printer, please use this port for kitchen
bell connection instead.
Wi-Fi Connection
To use Wi-Fi connection, please set up through official utility - Posiflex Wi-Fi
POS Printer Manager. There are two interfaces to organize PP-8800/8800E-W
which are USB and Wi-Fi. When the first time use PP-8800/8800E-W, please
set the host terminal’s Wi-Fi configuration to AD-HOC (peer to peer) mode
when setting through Wi-Fi interface. Another method to setup PP-
8800/8800E-W is by USB interface and please uses Wi-Fi POS Printer
Manager to setup Printer after USB connected.
Power Connection
The power connector is a 3-PIN jack between the peripheral connector and the
parallel connector for PP-8800/8800E. Either a Posiflex supplied power
adaptor or a printer power cable from a Posiflex POS system can be connected
to this connector to supply power for this printer. During insertion of the
power plug, be sure to hear the click to obtain a firm contact.
CAUTION: Before doing the insertion or extraction of the power plug, be
sure to pull the outer sleeve of the plug backward to release the
internal latch. Failure to do this could damage the power plug. Such
damage is considered as an artificial destruction and is not covered
by the warranty.
Power On
When all the above cable connections are made correctly, you may connect
your power adaptor to the wall outlet. Make sure that the type of power cord
and the voltage requirement of the power adaptor meet the local power
conditions. Now the printer is ready for power on.
Self Test
Press and hold down the feed button while turning the on
/ off switch on. The printer will then perform a self-test.
A sample slip of self-test result is printed as in the sample
at right. The sample slip will indicate the printer present
status and settings. If FEED button is pressed at this
moment, a font table will be printed in page mode again
for PP-8800&PP-8800E&PP-8800/8800E-S&PP-
8800/8800E-P and the PP-8800/8800E-L&PP-
8800/8800E-W will show IP information in this sample
slip. To exit the test printing, please turn the printer off
and on again.
