Porter-Cable 10 IN. (254 MM) JOBSITE TABLE SAW, Инструкция по эксплуатации

Страница: 13 / 40

13
Estimated Assembly Time: 45 - 60 Minutes.
For your safety, never connect plug to power source
receptacle until all assembly and adjustment steps
are complete, and you have read and understood
the safety instructions.
ASSEMBLING THE STAND (FIG. A)
1. Bag "O"
_
Attach one roller wheel to the rear leg
using the hex bolt (1), the two flat washers (2), the
sleeve (3) and the nut (4), as shown.
NOTE: Verify
that the side of the wheel that has more ribs (5) is
facing toward the stand.
2. Tighten the nut (4). NOTE: Do not overtighten,
because doing so will not allow the wheels to turn.
3. Repeat the above steps for the other roller wheel to
the front leg.
4. Bag "P"
_
Insert leg tube (6) into leg tube (7), join the
leg tubes by using bolts (8) and nuts (9).
Fig. A
SETTING UP THE STAND (FIG. B, C, D)
1. Lift up the left side of the stand as shown. (Fig. D)
2. Unfold the left side set leg (3) by releasing the
locking levers (2) from slot A to slot B, then rest the
left side of the stand onto the floor.
3. Release the hook (1) from the stop screw.
4. Raise the cover plate (4) on the right side of the
stand, pull the locking handle (5) out, and then lift the
stand slowly upward as shown. (Fig. D )
Fig. B
Fig. C
Fig. D
For your safety, never connect plug to power source
receptacle until all assembly and adjustment steps are
complete, and you have read and understood the safety
instructions.
ASSEMBLING TABLE SAW TO STAND (FIG. E)
1. Lift the saw body (1) and place on the stand (2),
aligning the four mounting grooves (3) of the saw
base with the four mounting holes on the top plate of
stand.
2. Bag "F"
-
Attach the table saw to the stand with four
hex head bolts (4) and washers (5).
3. Tighten all mounting bolts with a wrench.
Fig. E
ASSEMBLY AND ADJUSTMENTS
WARNING
!
SETTING UP
1 1 1 1
1
2
3
A
B
C
right side
4
5
6
1
2
3
2
8
7
4
9
6
5
WARNING
!
5
1
2
4
3