Porter-Cable 10 IN. (254 MM) JOBSITE TABLE SAW, Инструкция по эксплуатации

Страница: 21 / 40

21
square to the miter gauge bar by using a combination
square.
MITER GAUGE OPERATION (FIG. GG)
The miter gauge is accurately constructed with index
stops at 0º, 15º, 30º, 45º, 60º both right and left side.
To operate the miter gauge, loosen the lock handle (2)
and move the body of the miter gauge to the desired
angle. The miter gauge body will stop at 0º, 15º, 30º,
45º, 60º.
Fig. GG
RIP FENCE (FIG. HH)
1. Lift upward on the rip fence handle (1) so that the
holding clamp (2) is fully extended.
2. Place the rip fence on the saw table and engage the
holding clamp (2) to the table rear. Lower the front
end onto the front rail (3).
3. Push down on the fence handle (1) to lock.
Fig. HH
RIP FENCE ADJUSTMENT (FIG. II)
1. The fence (1) is moved by lifting up on the handle (2)
and sliding the fence to the desired location. Pushing
down on the handle locks the fence in position.
2. Position the fence on the right side of the table, and
along one edge of the miter gauge grooves.
3. Lock the fence handle. The fence should be parallel
with the miter gauge groove.
WARNING
!
Removing the blade guard and anti-kickback pawl
assembly (Fig. CC, DD)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
1. With the blade elevation handwheel raise the blade
to the maximum height.
2. Loosen the blade lock handle do not pull on handle
just turn and move the handwheel to 90° on the bevel
scale.
3. Tighten the bevel lock handle.
4. Remove the anti-kickback pawl assembly (3) by
pressing the anti-kickback pawls lever (1). (Fig. BB)
5. Remove the blade guard assembly (7) by pulling out
the locking pin (4). (Fig. EE)
AVOID KICKBACKS (FIG. FF)
(Work thrown back towards you) by keeping the blade
sharp, the rip fence parallel to the saw blade and by
keeping the riving knife, anti-kickback pawls and guards in
place, aligned and functioning. Do not release work before
passing it completely beyond the saw blade. Do not rip
work that is twisted, warped or does not have a straight
edge to guide it along the fence. Do not attempt to reverse
out of a cut with the blade running.
Improper riving knife alignment can cause
“kickback” and serious injury.
Fig. FF
MITER GAUGE ADJUSTMENT (FIG. GG)
1. Make sure that the miter gauge bar (1) will slide
freely through the table top grooves.
2. Loosen the lock knob handle (2) and turn the gauge
body (3) to set the pointer (4) at 0º on the scale.
3. Make a 90º cut in a scrap piece of wood. Check the
cut to see if it is 90º. If not, loosen the lock knob
handle (2) and move the miter gauge body until it is
WARNING
!
1
3
2
4
0
15
30
45
60
15
30
45
60
Anti- kickback pawl
1
2
3