Porsche 996 TT, Руководство по ремонту

Страница: 328 / 2099

B Insert for
torque
wrench
9626 Used to tighten the lock nuts of the camber and toe eccentrics at the rear axle to the
specified tightening torque. It can also be used for loosening.
C Torque
wrench
covering
the range
between 35
Nm (26
ftlb.) and
85 Nm (63
ftlb.) Commercially available; use in combination with tools A and B.
top of page
Vehicle height/wheel load
Note
There are few differences between suspension alignment on the new 911 Turbo and suspension
alignment procedures on the 911 Carrera (996)! •
As with the 911 Carrera (996) models, there is no adjustment facility for changing the vehicle height!
•
This applies to both the front and the rear axles! •
Since the vehicle height cannot be adjusted, it is not possible to adjust (fine adjustment) the
wheel−load difference between left and right at the rear and front axles! •
The varying strength of pads between coil springs and spring seats on the right and left spring struts on the
front and rear axles is not intended for changing the vehicle height but for compensating for differences in
coil−spring load groups.
Because of the different equipment versions (additional equipment), a greater wheel−load difference between
the left and right is permissible than previously was the case in Porsche suspension alignment for the 911
Carrera (996) (over 20 kg is possible). This is partly the result of heavier components compared with standard
equipment and partly results from additional components that are asymmetrically arranged.
top of page
Wheel−alignment corrections
Rear axle
WARNING
Danger of injury and damage to property due to malfunctions in the PSM control range if the steering angle
sensor is not calibrated or is calibrated incorrectly!
einordnung
Vehicle height/wheel load 265