Porsche 996 TT, Руководство по ремонту

Страница: 1888 / 2099

Suspension alignment − GT2
Suspension alignment, complete
Driving onto measuring platform
Tools
Deviating points for GT2
Notes on height changes/wheel−load changes
Vehicle height GT2
Wheel alignment
Instructions for fitting diagonal control arm on control arm GT2
top of page
Suspension alignment, complete
Note
The 911 GT2 suspension alignment contains only those procedures which deviate from those for the
911 Turbo (996) suspension alignment. •
top of page
Driving onto measuring platform
Due to the reduced vehicle height, additional access ramps, for example 959 access aids, are required to drive
the vehicle onto the measuring platform. Otherwise the front spoiler would bottom on the platform. A
measuring platform without a sloped position is unsuitable.
top of page
Tools
The special tools for suspension alignment of the 911 Turbo (996) are also used for the 911 GT2.
Additionally, a hook wrench insert (special tool 9647) is required for the 911 GT2. The special tool 9647 is
required to change the vehicle height and to adjust the stabilizer mating bearing on the front and rear axle. The
special tool is used together with a torque wrench to tighten the lock nuts (slotted nuts) on the spring struts.
Tightening torques in Repair Group 40/42.
Suspension alignment − GT2 1825