Porsche 996 TT, Руководство по ремонту

Страница: 1008 / 2099

3 Install impact pipe −19− or impact
absorber (USA version) −19 A− Position impact pipe −19− or impact absorber −19 A−
with seal −20− or −20 A− and screw on with fastening
screws −21− . => Tightening torques
4 Install rear bumper −8,− or −(8A)−
(USA version) Position the heat shield−9− together with the rear support
−14−
and screw on using fastening screws −12− .
=> Tightening torques
Position connecting angle −15− and screw on using
fastening screws −13− .
Position the rear bumper −8, (8A)− with the mounted
heat shield −9− and screw on with fastening screws −10−
. => Tightening torquesScrew in sheetmetal screws −11−
.
Check the adjustment dimensions of the
rear bumper and the assembly of the
heat shield and correct if necessary => Additional assembly instructions for installation of
the bumper
5 Installing centre retaining strip −5− Position centre retaining strip −5− with sheetmetal nuts
attached −7− and screw on with collar nuts −6− .
Note:
observe adjsuting dimension! => Additional assembly
instructions for installation of the bumper => Additional
assembly instructions for installation of the bumper −
Carrera 4S
6 Put on anti−chafing film −3− Put on sheetmetal nut −4− and align. Stick on
anti−chafing film −3− with clearance −U = 8 mm− .
Note:
make sure that the anti−chafing film seals off the recess
of the sheetmetal nut completely.
7 Install retaining strip at the sides −2− Put on retaining strip at the sides −2− so that the
clearance rib −arrow− of the retaining strip rests against
the side section without gaps and screw on with the collar
nuts −1− .
Use the instructions => Removing and installing frame
with heat shield for type Carrera 4S.
Installing rear spoiler => Install rear spoiler
top of page
Additional assembly instructions for installation of the bumper
Adjustment dimensions of the bumper
einordnung
Additional assembly instructions for installation of the bumper 945