Porsche 996 TT, Руководство по ремонту

Страница: 1671 / 2099

69 74 19 Removing and installing control module for
roll−over protection system
Removing control module
Installing control module
Tools and materials
top of page
Removing control module
1. Remove ignition key
2. Disconnect the battery and cover terminal or battery.
3. Only loosen the centre console and move it forwards a little. => Removing and installing center console
4. Remove the two rear belt buckles and take out the seat wells.
5. Undo the trim of the seat wells from the carpeting and lift up in the middle.
6. Using a support tool, support the trim and unscrew and remove the plastic screw from the control module
cover.
7. Disconnect the electrical plug connection. Undo the shear−off nuts with socket wrench insert => Tools
and materials, and remove the roll−over protection control module.
top of page
Installing control module
1. Install the roll−over protection control module in the centring holes with the fixing pins, and secure with
shear−off nuts.
2. Use a 1/4 inch Allen key to tighten the shear−off nuts.
3. Engage electrical plug connection and route wire carefully. Install control module cover, seat wells,
belt buckles and centre console.
69 74 19 Removing and installing control module for roll−over protection system 1608