Adjust the light intensity
The initial setting is maximum intensity. While the light is illuminated, press button “Bright –“ on
remote control to reduce the intensity. Pressing at 4th time will get the minimum intensity. To get
higher intensity, press button “ “.
Adjust the color scrolling / flashing speed
The initial setting is SLOW for color scrolling mode and color flashing mode. You can press the
button “QUICK” to change to a faster speed
Mode Selection by pressing button on the light
Press and hold the button (below) for 2 seconds to power on the light.
- Button on the bottom of pool and patio light
After power on, the light will start in scrolling mode, Press the button as follows :
Press 1st - 7zth time– Select individual color
Press 8th time – Go to color flashing mode in SLOW speed.
Press 9th time – Return to the individual color mode and then flashing mode again as above.
To power off the light, press and hold the button for 2 seconds.
Battery replacement (for remote control)
If remote control fails to activate the light, replace the battery.
- Press the tab on side of battery cover and then slide off the cover from the remote control.
- Take out the battery and replace a new one. Pay attention to the polarity of battery on the cover
and
cover direction when installing them back to the remote control.
Warning!
- Make sure that battery is inserted the right way around and with the correct polarity
- Remove exhausted battery from the product
- The supply terminals are not to be short-circuited
- Dispose of battery safely.
Caring for your light
- Always POWER OFF the light after use.
- Use clean water to rinse the light after use, and dry with a clean cloth.
- Store the light out of reach of children and direct sunlight.
