Step By Step Instructions
Turn the motor and non-motor end upside
down. This is done to appropriately attach
the roll-up tube and the mechanism
mounting feet.
Attach the roll-up tube to the non-motor end
of the mechan
ism
using the 3/8” x 1-1/4”
bolts (27) and lock washers (28) provided.
To attach the feet, first measure the distance
from the bottom of the cover box to the top
of the track/retainer (This will determine the
height of the mechanism.)
Attach the mechanism feet to the mechanism
approximately 1 inch less than the distance
from the bottom of the cover box to the top
of the track/retainer. Use a 7/16 inch ratchet
to tighten bolts.
Tip: The roll-up tube should be set as high as
possible without allowing the cover rub on
the lid brackets.
Installing the Mechanism in the
Cover Box.
Line up the mechanism with the track so
the rope will come straight out and around
the motor end pulley.
Center the tube in the cover box. Tip: If
the pool is not square, square up the
mechanism with the track.
Attach the mechanism feet to the floor of
the cover box. Use the mounting hardware
provided.
1
2
3
4
5
6
7
8
9
Loosen the four nylock nuts on the pulley
brackets. Raise the pulley bracket assembly
so it is level with the bottom of the track.
Attach the roll-up tube to the motor end of
the mechan
ism
using the 3/8” x 1-1/4” bolts
(27) and lock washers (28) provided.
© Latham Pool Products, Inc. 2016. All rights reserved.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Numbers in parenthesis refer to hardware shown on page 3.
Assembling the Mechanism.
9 of 20