Rope Reel
Attach the rope to the rope reel. Guide the
ropes onto the rope reel while operating
the key switch in the cover pos
i
tion.
Tip: The rope for the non-motor side should
be attached approximately 1 inch further
down than the motor side rope depending
on the width of the pool. Use the switch
and operate the cover in the “Closed”
position to cover the pool.
Pinning the Cover to the Roll-up
Tube
Using a self-tapping screw (32), line the cover
up straight as it comes out of the track and
pin the cover to the roll-up tube on both sides
The cover must be open when cutting and
attaching the ropes.
Pull the cover back
until the sliders are against the guides. Pull
the ropes tight as they come off the pulleys
on the mechanism to eliminate the slack in
the rope.
While pulling both ropes tight, use a lighter
or torch to burn the rope in the location it
will be cut. This will help them not fray after
they have been cut. Cut the ropes so they
are at least 8 ft long. Use the lighter to burn
the cut ends of the rope if needed.
Find the center of the slack and pin directly
to the tube (DO NOT FOLD THE SLACK).
Repeat this step several times along the
tube
Tip: Use the weld line on the tube to help
pin the cover straight on the tube.
Using a self-tapping screw (32) , attach the
bonding wire on both sides of the roll-up
tube.
Make sure that the cover and the webbing roll up nice and
even around the roll-up tube.
Operate the cover several times to and make any adjustments
to the rope reel brake and roll-up tube brake if necessary.
The Mini Infinity 2 installation is complete.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
Step By Step Instructions
Numbers in parenthesis refer to hardware shown on page 3.
Attaching the Ropes to the
37
38
39
40
41
4
4
2
3
17 of 20