15
6.2 Automatically scan
input 1 “COPY INPUT 1“
By selecting the menu
“COPY INPUT 1“
an automatic scan of input 1 is possible. Input 1 is scanned and the
available transponders are listed at the output. The number is limited to a maximum of 32 transponders.
In the sub menu
”MODE“
the desired SCAN mode can be selected. Available modes are shown in the following
table:
MODE
INPUT SIGNAL
OUTPUT SIGNAL
OFF
- (manually programming necessary)
- (manually programming necessary)
Qlo
Qlo
QUATTRO LOW
(950 MHz … 1950 MHz)
QUATTRO LOW
(950 MHz … 1950 MHz)
Qlo
Wlo
QUATTRO LOW
(950 MHz … 1950 MHz)
WIDEBAND LOW
(290 MHz … 1290 MHz)
Wlo
Qlo
WIDEBAND LOW
(290 MHz … 1290 MHz)
QUATTRO LOW
(950 MHz … 1950 MHz)
Wlo
Wlo
WIDEBAND LOW
(290 MHz … 1290 MHz)
WIDEBAND LOW
(290 MHz … 1290 MHz)
Qhi
Qhi
QUATTRO HIGH
(1100 MHz … 2150 MHz)
QUATTRO HIGH
(1100 MHz … 2150 MHz)
Qhi
Whi
QUATTRO HIGH
(1100 MHz … 2150 MHz)
WIDEBAND HIGH
(1290 MHz
… 2340 MHz)
Whi
Qhi
WIDEBAND HIGH
(1290 MHz … 2340 MHz)
QUATTRO HIGH
(1100 MHz … 2150 MHz)
Whi
Whi
WIDEBAND HIGH
(1290 MHz … 2340 MHz)
WIDEBAND HIGH
(1290 MHz … 2340 MHz)
W
W
WIDEBAND
(290 MHz … 2340 MHz)
WIDEBAND
(290 MHz … 2340 MHz)*
* ATTENTION: In this mode, the entire frequency range is scanned. The first 32 transponders are available at the
output.
After selection of the SCAN mode and pressing of the menu item
”START SCAN“,
the automatic scan will be
activated. Confirmation is
done via a
short press of the rotary button.
Programming sequence and display:
If it is necessary to change the transponders found, this can be done in the menu
”Input SAT 1- 4“
via the item
”INPUT SAT 1“
. The transponders from the scan are displayed here.
Scan of the available transponders at input 1
Selection of the Scan mode according to the table and start of the scan
Display scanning process, time ca. 30 seconds
Completion of scan, display of the number of found transponders
