7
A message indicating that the
Product Activation Key
was loaded
successfully appears. The red ERR LED on the Media card turns
OFF and the green RDY LED turns ON.
As no
Default IP Network Service
is defined, the system
automatically starts the
Fast Configuration Wizard
.
Initial System Configuration
The
Fast Configuration Wizard
that is automatically started enables you
to configure the
Default IP Service.
The
IP Management Service
tab in the
Fast Configuration Wizard
is enabled
only if the default Management IP addresses were not modified.
1
In the
Fast Configuration
Wizard
-
IP
dialog box, define the following
parameters:
2
Click
Next
.
•
IPv4 is the default protocol for setting the Network Service in the
Fast Configuration Wizard.
•
If
Secured Communication
is required on the RMX: complete the
Fast Configuration Wizard
, Login, install the
Certificate
and then
enable the
Secured Communication Mode
.
Field
Description
IP Service
Name
Use the default name (Default IP Service) or enter a name
using up to 20 characters.
Note:
This field is displayed in all dialog boxes.
Signaling Host
IP Address
Enter the IP address of the Central Signaling host. This is
the address used by endpoints for dialing in to the MCU.
Media Card 1/2/
3/4 IP Address
Enter the IP address(es) of the media card (s): MPMx 1,
MPMx 2, MPMx 3 and MPMx 4 (if installed), as provided
by the network administrator. Endpoints connect to
conferences and transmit call media (video, voice and
content) via these addresses.
Subnet Mask
Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
