LECOASPIRA PROGRAM
169
ENGLISH
Empty the container by tilting it towards the spout (Fig.10).
Pull the elbow tube (
27
) from the filter body with the micro pore net (
26
) until it slides off (Fig. 11a).
Separate all the components and rinse them under running water. (If the filter sponge has tears,
replace it. To purchase one, contact an authorized Polti Service centre).
After drying the various components of the “Eco-Active ” water filter, reinsert the water filter assem-
bly, in the water container (
20
).
ATTENTION: align the arrow located on the elbow pipe (
27
) with the reference notch located on
the filter body (
26
) (Fig. 11b - 11c).
Replace the water container (
20
) as described in the chapter “preparing for use”.
A recommendation for cleaning the container and the extension tubes, if particularly dirty:
once cleaning is complete, empty the container as described and place it back in its housing on the
body of the appliance. Connect the appliance to the mains.
Then vacuum up approximately 1.5 litres of clean water using the suction function for a few
seconds.
The water vortex created inside the container will rinse the sides and remove any dirt. The clean
water will also clean the inside of the tubes as it travels through them.
Empty the container again and put Vaporetto Lecoaspira away.
3) CABLE STORAGE
Before putting Vaporetto Lecoaspira away, store the power cable (
13
) in the specific space (
15
)
proceeding as described below::
• Remove the water container (
20
) as described in the chapter “preparing for use”.
• manually wind the cable evenly and replace it in the specific space (
15
), making it go into the
cable storage (
14
) (Fig. 8);
• replace the water container (
20
) in its storage making sure to position it correctly.
4) WASHABLE HEPA FILTER
ATTENTION: the HEPA filter (
17
) included with Vaporetto Lecoaspira is washable. To clean the fil-
ters, proceed as follows:
• Unhook the water container handle (
22
) and remove the container (
20
) as described in the chap-
ter “PREPARING FOR USE”.
• Lift the HEPA filter release lever and remove the filter (
18
) from its housing (fig.12).
• Rinse the filter under cold running water.
After washing it, shake it gently to eliminate any reside of dirt and excess water.
NOTE: allow the filter to dry naturally, away from direct sources of light and heat. It is advisable
to wait 24 hours before replacing the filter in the appliance.
• Replace the filter with a new one if it is torn.
• The filter should be cleaned every 4 months.
• To correctly position the HEPA filter (
17
) make sure that it is lodged in its housings (
19
) and is
then blocked by the lever (
18
) (Fig.14).
ATTENTION:
• Do not clean the filter with the brush as it can be damaged, thereby reducing its filtering capacity.
• Do not use detergents, do not rub the filter, and do not wash it in a dishwasher.
LECOASPIRA
PROGRAM
- M0S10133 1S01_7:Layout 1
04/05/2012
10.07
Pagina 169
Содержание VAPORETTO LECOASPIRA PROGRAM
Страница 1: ...PROGRAM...
