7.Sensor mounting
11
ADEBUS & GAPID EXPLORER
Placement and installation height
This type of sensor has the optimal sensitivity of a diameter of 5 metres on all types of fences, metal
structures and gates.If the fence is supported by poles about 5 metres apart, position the sensor in the
centre of this distance, so as to place one in each "sector".
However, it is necessary to take into consideration the type of material of the fence since, depending
on whether it is loose mesh, electro-welded or with panels, the material will transmit a different
sensitivity.
POLITEC | INSTALLATION MANUAL - VER.1.8
Position the Gapid in the centre of the panel
or the mesh and screw it to the fixing plate
positioned on the other side.Tighten the
screws firmly to prevent the device from
moving.
Fasten the cable with cable ties to the fence or support
on which you have mounted the Gapid SR and wire the
sensors.
After calibration and programming, close the device
making sure that the gasket is well positioned inside
the special compartment and that the protective cover
closes well.
The Gapid SR can be connected to the net and to the
Adebus control unit only with the cable supplied which
is RS485.
The cable must be inserted in the two slots below: one
for input and one for output.
After that, wire the sensors.
The last sensor in line will only have the input cable.At
this point, unscrew the 4 screws of the cable gland
plate and replace the perforated gasket with the
supplied cap
WARNING:
Product warranty is invalid if there is any hole in the product profile or any component
