P. 12
Installation
Guide
PS-4660TW
12 YELLOW
(+) Glow-Plug
input
(cont.)
•
Connecting the glow-plug input wire of the
module
to ignition
will hold the ignition
ON
for
the maximum waiting time (15 seconds
recommended)
•
Keeping the module’s glow-plug input wire
unconnected
will hold the ignition ON for the
minimum waiting time (3 sec., not recommended
in very cold environments).
Connect the glow-plug wire to the ignition wire only
after the tach programming has been completed:
connecting the glow-plug wire is one of the very last
steps in the installation process.
2-Pin Harness
Wire Colour
Function
Description
1
BLUE/
WHITE
(–) AUX 2
output
This 500 mA negative output can be programmed
for one of the following Options:
1.
Constant while the
SHIFT
button followed by the
LOCK
button, + 1 sec. after the buttons are
released.
2.
Pressing
SHIFT
button followed by the
LOCK
simultaneously toggles the output
ON
and
OFF
with automatic toggle
OFF
after 30
seconds.
2
YELLO
W
(–) Parking
Light
output
500 mA negative parking light output
Note:
Ensure that the voltage does not vary
when the dimmer control switch is turned up or
down. If this is the case, it is not the right wire.
There is also a positive parking light output.
Only one of these two different outputs needs
to be connected.
Flashing the Hood-Pin Switch
Flashing the hood-pin switch is a procedure that brings the module into programming
mode. Once the module is in programming mode, the installer will have a maximum of
20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu
before the 20-second delay, the module will exit the programming mode and the installer
will have to flash the hood pin switch once more.
Tip
As long as the hood is up, you may use the
programming assistance button instead of the hood-
pin switch.
