PS-4660TW
Installation Guide
P. 15
Note:
The unit will stay in the selected programming mode until the hood pin-switch or the brake
pedal is pressed again.
Therefore take your time to make the proper selection.
Pressing the
brake pedal will take you back to the programming centre, where you can select a different mode.
1.
With the key inserted in the ignition switch, turn the key from the OFF position to the
ON position and then back to the OFF position.
2.
Press and hold the valet switch for three (3) seconds.
3.
The LED will turn ON solid.
4.
Press and hold the brake pedal,
– And press one of the following buttons on the transmitter:
•
LOCK
to access mode 1;
•
UNLOCK
to access mode 2;
•
TRUNK
to access mode 3;
•
START/STOP
to access mode 4.
The parking lights
will flash
and the horn
will
honk
once, twice or three times to confirm entry into a
mode (if the horn is configured).
5.
Release the brake pedal.
6.
To exit the programming centre, press and hold the brake pedal for three (3) seconds.
Table 3
Note
The Unit will stay in the selected programming Mode until the Hood Pin-
switch or the Brake Pedal is pressed again.
Therefore take your time to
make the proper selection.
Pressing the Brake Pedal will take you back to
the Programming Centre, where you can select a different Mode.
Once you access a particular programming Mode, you will automatically start at
Function 1. Once you select one of the Options of Function 1, you will automatically be
taken to the next Function.
To select one of the four Options
of any given Function, press the corresponding
button on the Transmitter:
•
LOCK
button .............................to access option 1
•
UNLOCK
button .........................to access option 2
•
TRUNK
button ...........................to access option 3
•
START
button ............................to access option 4
•
SHIFT
then
LOCK
buttons............to access option 5
Table 4
In each Function, once an Option has been selected THE Parking Lights will flash 1, 2, 3
or 4 times (depending on the selected Option).
Please note
that the different Functions within any particular Mode can only be accessed
sequentially: the Programming Centre will move from Function 1 to Function 2, then to
Function 3, and so on. Therefore, whenever you access a particular Mode, be prepared
to re-configure all the Functions of that Mode in ascending order.
