PS-4660TW
Installation Guide
P. 7
This wire provides a +12 V output and must be
connected on the vehicle to the parking lights wire
that tests +12 V when the light switch is in the
ON
position.
5
YELLOW
(+) 12 V
Parking Light
output
Note
: ensure that the voltage does not decrease or
increase when the dimmer control switch is turned. If
the voltage goes up or down, find another parking
light wire.
12-Pin Accessories Harness
Wire Colour
Function
Description
1
BLUE
(–) Trunk /
AUX 3 output
500 mA negative output. This output can be used to
control the trunk release (1-sec. pulse), or it can be
set to operate as a constant output as long as the
TRUNK
button is held pressed (for sunroof or window
closure)
2
BROWN
(–) Lock
output
Programmable 500 mA negative output: 1/10-sec.,
7/10-sec. or 4-sec. pulse
3
GREEN
(–) Unlock
output
Programmable 500 mA negative output: 1/10-sec.,
7/10-sec., 4-sec. or double 1/4-sec. pulse (
ON
250 ms,
OFF
500 ms,
ON
250 ms).
4
WHITE /
BROWN
(–) Rearm
output
500 mA ground signal when the doors are locked by
remote control. This wire will go to ground 1/2 sec.
before the
LOCK
pulse, and go out 1/8 sec after
LOCK
.
The wire must be connected to the OEM arm wire
(usually the door pin).
Note:
The module will also give a rearm pulse on
this wire when it shuts down the vehicle after a
remote start.
5
WHITE /
GREEN
(–) Disarm
output
500 mA ground pulse when the doors are unlocked
by remote control. Connect to the OEM disarm wire
of the vehicle.
Note:
The system will also give a disarm pulse on
this wire before every remote start.
6
BLUE /
WHITE
(+) Positive
Door input
This input should be used in vehicles with
positive-
switching
Door pins or Dome Light circuits.
Connect to the Dome Light wire that tests +12 V
when a Door is open.
