6 I
GB
Not 1:
Your TV will switch to the
STANDBY
mode in five minutes if there is no broadcast
signal from antenna.
Note 2:
Your TV is equipped to
operate with TV buttons in case
your R/C is broken or the batteries
are exhausted.
3.
To power on your television,
press any numerical key or
PR+
or
PR-
keys on the remote control.
For this process, you can also
use the buttons on your TV. The
picture will appear on the screen
after a short while.
Note:
If you are not going to use your
television for a long time, unplug its power
cable from the socket.
Initial power on and performing
settings
To set up your television, read the sections
on the TV controls and making the channel
settings.
4.3-Batteries
Open the lid of the battery compartment
and make sure that you have placed the
batteries in the correct direction. For this
remote control, UM-4, IEC R03 or AAA 1.5 V
batteries are suitable.
Do not throw your old batteries into the fire,
discard them in a dedicated waste area for
this purpose.
Do not mix used batteries with new ones or
different types of batteries together.
The performance of the remote control will
be reduced at a distance of 8 meters from or
at an angle of 30 degrees beyond the centre
of the TV.
4
Start
Remove your television carefully from its
box. You can keep the packaging of your
television to use in future.
Contents of the box
Power cable
Remote control
2 batteries
Note: Scart, HDMI, VGA and RCA cables
are not supplied with the device.
4.1-Antenna connection
If you use a 75 Ohm coaxial cable (round
cable) as an antenna cable, connect the
antenna plug directly to the antenna input
located on the TV.
Motorized vehicles, energy lines and
telecommunication lines affect your antenna.
Therefore, be careful to install your antenna
away from these and metal surface in such
a way that it shall not swing. Do not make
your antenna cable longer than required
and do not coil it. Make sure that it is not
crimped passing through a window or door.
Your antenna and cable might be affected by
natural phenomena such as rain, wind, smoke
and humidity over time. Periodically check
your antenna and equipment.
4.2-Powering on your device
and the initial use
1.
Insert the power cable into the power
supply input located on the back panel of the
LCD TV.
2.
Insert the power cable plug supplied with
the device into the mains socket.
or
