6 I
k
is no broadcast signal from antenna.
Note 2:
Your TV is equipped to operate
with TV buttons in case your R/C is
broken or the batteries are exhausted.
3.
To power on your television,
press any numerical key or
STANDBY
,
PR+
or
PR-
keys
on the remote control. For this
process, you can also use the
buttons on your TV. The picture
will appear on the screen after
a short while.
Note:
If you are not going to
use your television for a long
time, unplug its power cable
from the socket.
Initial power on and performing the
settings
To set up your television, read the
sections on the TV controls and making
the channel settings.
4.3-Batteries
Open the lid of the battery compartment
and make sure that you have placed the
batteries in the correct direction. For this
remote control, UM-4, IEC R03 or AAA
1.5 V batteries are suitable.
Do not throw your old batteries into the
fire, discard them in a dedicated waste
area for this purpose.
Do not mix used batteries with new
ones or different types of batteries
together.
The performance of the remote control
will be reduced at a distance of 8 meters
from or at an angle of 30 degrees
beyond the centre of the TV.
4
Start
Remove your television carefully from
its box. You can keep the packaging of
your television to use in future.
Contents of the box
Power cable
Remote control
2 batteries
Note: The Scart, HDMI, VGA and
RCA cables are not supplied with
the device.
4.1-Antenna connection
If you use a 75 Ohm coaxial cable
(round cable) as an antenna cable,
connect the antenna plug directly to the
antenna input located on the TV.
Motorized vehicles, energy lines and
telecommunication lines affect your
antenna. Therefore, be careful to install
your antenna away from these and
metal surface in such a way that it shall
not swing. Do not make your antenna
cable longer than required and do not
coil it. Make sure that it is not crimped
passing through a window or door. Your
antenna and cable might be affected
by natural phenomena such as rain,
wind, smoke and humidity over time.
Periodically check your antenna and
equipment.
4.2-Powering on your device
and the initial use
1.
Insert the power cable into the power
supply input located on the back panel
of the LCD TV.
2.
Insert the power cable plug supplied
with the device into the mains socket.
Note 1:
Your TV will switch to the
stand-by
mode in five minutes if there
