ENGINE
3.55
(PA--45658)
32. Before installing the gear/stator housing cover,
install the Water Pump Seal Saver (
PA--45401
)
onto the water pump shaft.
PA--45401
33. Install the new gasket to the gear/stator housing
cover and crankcase. With the tools installed,
carefully place the gear/stator housing cover over
the protection tools.
NOTE:
New gasket is not
shown in the picture.
34. Apply Crankcase Sealant (
PN 2871557
) to the
outside edges of the crankcase halves (See
arrows), where the crankcases mate. (See
photos below.) This helps to prevent coolant
leakage.
35. Install the gear/stator housing gasket onto he
crankcase.
Gear/Stator
Housing Gasket
36. Secure the gear/stator housing cover (O) to the
crankcase with the cover bolts. Torque bolts to 96
±
12 in.lbs. (10.85
±
0.35 Nm) in proper tightening
sequence (see Pg. 3.3). Remove seal protectors
from the shaft ends once secure.
Содержание Sportsman 800 Efi 2005
