Polaris RANGER 1000 2020, Руководство по обслуживанию

Страница: 125 / 610

2
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
2.37
COOLANT LEVEL INSPECTION
INSPECTION
The recovery bottle
q
and radiator pressure cap
w
are
located under the hood.
1. Position the vehicle on a level surface
2. Remove the hood from the front cab.
3. Check the coolant level in the recovery bottle. The
coolant level must be maintained between the “MAX”
and “MIN” levels indicated on the recovery bottle.
4. If the coolant level is below the “MIN” mark, inspect
the coolant level in the radiator.
NOTICE
If overheating is evident, allow system to cool
completely, and check coolant level in the radiator and
inspect for signs of trapped air in system. Refer to
Coolant Service page 3.80 as needed.
CAUTION
Never remove the pressure cap when the engine is
warm or hot. Escaping steam can cause severe burns.
The engine must be cool before removing the pressure
cap.
ADJUSTMENT
1. Remove the pressure cap. Using a funnel, add
coolant to the top of the radiator filler neck.
CAUTION
Never remove the pressure cap when the engine is
warm or hot. Escaping steam can cause severe burns.
The engine must be cool before removing the pressure
cap.
2. Reinstall the pressure cap.
NOTICE
Use of a non-standard pressure cap will not allow the
recovery system to function properly.
3. Remove the recovery bottle cap and add coolant
using a funnel.
4. Fill the recovery bottle to the “MAX” mark with the
recommended pre-mix coolant. You may use a 50/50
or 60/40 mixture of antifreeze and distilled water as
required for freeze protection in your area.
Recommended Anti-Freeze/Coolant:
Polaris 50 / 50 Extended Life Antifreeze
5. Reinstall the recovery bottle cap.
6. If coolant was required, start engine and check for
leaks. Make sure radiator fins are clean to prevent
overheating.
MAINTENANCE