Polaris 850 PRO-RMK 155 2.6" QD 2021, Руководство пользователя

Страница: 522 / 747

8.36
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
© Copyright Polaris Inc.
SHOCKS
FRONT TRACK SHOCK (FTS) SERVICE
Front Track Shock (FTS) Assembly Removal
1. With the snowmobile sitting on a flat surface, note the
where the limiter strap screw is installed. Remove the
fastener securing the top of the limiter strap to the
front torque arm cross shaft.
NOTICE
Limiter strap fastener shown in the stock (upper hole)
position.
2. Raise the rear of the snowmobile off of the ground
using a dedicated track stand or similar device. Do
not lift snowmobile by the rear bumper as doing so
will compress the rear track shock.
3. Measure the shock preload setting.
4. Remove the fastener securing the shock rod to the
front torque arm. Discard the lock nut.
5. Remove the two screws securing the FTS cross shaft
to the left and right rail beams. Note there is a washer
on each screw.
6. Slide the FTS/ cross shaft assembly rearward and at
an angle to remove the rail beams.
NOTICE
The cross shaft washers will stay in the rail beams. Do
not misplace these washers.
STEERING / SUSPENSIONS