6.
Press the STORE/LAP button
repeat-
edly to cycle through all the recorded split/lap
times and heart rates.
7.
Once the
lap/split time appears on
display again,
press SET/START/STOP
button
to return to step 1 on this list
8
To leave the
press the SELECT
button
to go to TIME mode).
C A R E A N D
M A I N T E N A N C E
W R I S T R E C E I V E R
The rubber gasket seals that ensure water
on the Wrist
deteriorate
over time. It is recommended that these seals
are replaced after two years of use.
is
particularly important if you are using your Polar
Accurex NV HRM for swimming.
P O L A R T R A N S M I T T E R A N D
T H E E L A S T I C S T R A P
The Polar Transmitter is an
mode only
when it is attached to the chest for measure-
ment It should not be activated when it is not
worn However, sweat and other
on
the Transmitter can keep it running after is
removed from the body. Therefore. to avoid
wasting battery energy, you should
wipe dry
and clean the Transmitter when need-
ed.
The Transmitter and the
strap can
be washed with a mild soap and water solution.
However, never use alcohol or any abrasives
such as steel wool or
They
c a u s e p e r m a n e n t d a m a g e t o t h e
electrodes.
Note’ Do not stretch or bend the
of the
Transmitter.
when storing
(more
needed to store it in the
container), because this
damage their
conductivity.
B A T T E R I E S
In order to ensure the water resistance of the
HRM, the
batteries
of the Wrist Receiver
should only be replaced by a person
authorised by Polar
Oy.
F o r
details, contact vour dealer or
To conserve battery life, the
Receiver is
programmed to automatically return to the TIME
selection after ten minutes. when no buttons
have been pushed and no heart rate has been
received from the Transmitter. In MEASURE
mode, the receiver circuitry voltage
IS
cut off
minutes, if no heart rate has been
received. As an indication of
the lowest
of
show but the stopwatch keeps
on
to facilitate time measurement without
heart rate information
