EN
33
3.3 Wireless Keys
Pairing a New Wireless Key
- Select ”Main Menu->Parts->Remote->Add”.
- “Synchronizing” is displayed, the system goes into the sniffer mode and count down
the pairing time remaining .
- Press one button of wireless key to send a transmission signal to the panel.
- As the serial number of wireless key is added to panel, “Leaning OK”will be
displayed.
The system will display“Device code has been learnt”if serial number of wireless key
have been learned.
Delete
- Select “Main Menu->Parts->Remote->Delete”.
- Use the buttons to scroll to the serial number be deleted.
- Press to delete the selected serial number.
Delete All
- Select “Main Menu->Parts->Remote->Delete All”.
- A total number of serial numbers learned is displayed.
- To delete all the serial numbers, press
3.4 Wireless Sensors
Pairing a New Sensor
- Select “Main Menu->Parts->Detector->Add”.
- Use to scroll to , then use to scroll to the desired Zone Name.
- Use to scroll to , then use to scroll to the desired Zone Mode(Type).
You must assign a Zone Type to each zone(sensor), which defines the way in which
the system responds to faults in that zone.
“Stay Arm Active”
usually assigned to sensors or contacts on entry and exit doors,
exterior doors and windows, perimeter. Active when armed in AWAY or STAY mode.
“Out Arm Active”
usually assigned to a interior area (i.e.: foyer, lobby,or room).
Bypassed automatically when armed in STAY mode.
“24 Hours Active”
usually assigned to a zone containing an Emergency Button,
Smoke Sensor, CO, Water Leakage and Gas Sensors.
To used as doorbell, select
“Doorbell”
.
To disable the zone, select
“Close”
.
- Use to scroll to , then use digits keypad to enter the Zone Number (0-89 are
available). The Zone Number should be unique.
- Press ,“Synchronizing” is displayed, the system goes into the sniffer mode and
count down the pairing time remaining .
- Active wireless sensor to send a transmission signal to the panel.
- As the serial number of wireless sensor is added to panel, “Leaning OK”will be
displayed.
The system will display“Device code has been learned” if serial number of wireless
sensor have been learned, and the Zone Name/Mode/Number will be refreshed.
