Precision Measurement Engineering, Inc.
(760) 727-0300
www.pme.com
21
2)
Remove the depleted batteries
noting the position of the (+) terminal
.
3)
Use only new, fully charged batteries, both of the same type.
4)
Install fresh batteries with the
(+) position the same as the removed batteries
. The
(+) position is also marked on the inside of the battery holder.
5)
The miniDOT Logger’s LED Light should flash to indicate that the software is
beginning operation within a second or two after you complete the battery installation.
At this time the logger will enter the mode selected by the Logger Control Switch
(which should initially be “Halt
”
from Step 1).
Please be aware that the warranty will become void if the batteries are installed
backwards.
3.5 Installing Copper Mesh or Plate
miniDOT Anti-Fouling Copper Kit includes
:
1 Cu Wire Mesh Disc
1 Cu Plate
1 Nylon Ring
3 Phillips Pan Head Screws
How to install the Cu mesh on a miniDOT Logger:
1. Use a Phillips screwdriver to remove 3 of the 6 screws (every other one). Do NOT
remove all screws. At least 3 must remain screwed in at all times.
Save the ss316 screws. They will be needed if the Cu mesh is removed.
