Plus N-20 Series, Руководство по сборке и настройке

Страница: 3 / 17

E-2
1. PLEASE READ IN THE INTEREST OF SAFETY
Warning
• If you are not a qualifi ed assembly serviceperson, do not perform installation procedures.
• Please be sure to perform the installation and assembly based on this manual. Incorrect installation
or assembly will be the cause of injury.
• Please have 2 or more persons lift the main unit when installing or removing it.
Also, be sure to lock the stand's casters before installing or removing. If not, the stand could slip un-
expectedly, resulting in accidents.
• To prevent dropping the strength of the installation location and the anchoring method must fully bear
over a long period the load of the main unit, printer, and installation parts. The installation should also
be performed to fully withstand an earthquake. Incorrect installation can result in the main unit falling
and causing injury.
• Please use M5 or equivalent screws for the wall mounting portion. Use of screws other than M5 or
equivalent can result in the main unit falling and causing injury.
• Please mount to a post in the wall or a sturdy wall stud. When the mounting positions of the main unit
are not reached, please use optional wall support fi ttings.
• Please use hardware like anchor nuts and anchor bolts for mounting on a concrete wall.
• Be sure to install the stabilizers supplied with the stand at each of the 4 locations (to prevent top-
pling).
• The AC adapter box is for storing the AC power adapters of the main unit and printer. The AC power
adapters and the power cords heat up. Read the "Important Safety Information" included with the
main unit carefully and store the AC power adapters properly.
CAUTION
* The Velcro is meant to prevent slipping, not to fasten the printer in place.
* Velcro is a registered trademark of Velcro Industries.
• Diagrams of printers that appear in this manual are representative illustrations.
The illustration will differ from the actual printer. Check the owner's manual of your printer for information about the names of
the connectors and their locations and use.
Note
• When mounting the printer on the main unit, attach the Velcro to prevent the printer from slipping out
due to vibrations.
Remove the printer when moving the main unit. If not, the printer could fall, resulting in damage or
injury.