Plinius KAITAKI, Инструкция по эксплуатации

Страница: 18 / 22

16 PLINIUS KAITAKI
Product Features
REMOTE CONTROL
Provided with your Kaitaki Preamplifier is a 17 function remote control. Two AAA
batteries power the remote, and these are replaced by removing the two screws on
the base of the remote that hold the battery compartment in place. The bottom end
of the remote is now free to slide out for access to the batteries. Replace the two
batteries, taking care to refit the new ones with correct polarity.
PHONO OPTION
The internal Phono stage is an optional accessory. If your unit is not fitted with an
internal phono stage, an external phono preamplifier can be used, or an additional
line level source can be connected.
PHONO GAIN ADJUSTMENT
The phono stage can also be set to high or low gain to suit your phono turntable
specifications (high gain is the factory setting). Disconnect the lead from the IEC
socket on your Kaitaki Preamplifier and make sure the Mains switch is OFF. Carefully
remove the lid by undoing the cap screws on the top and side. Locate the small
black phono jumpers set in the middle of the phono circuit board. The gain can now
be adjusted noting that high gain (factory setting) is set with jumpers toward the
base, and low gain is set with jumpers toward the lid. Now re-assemble your Kaitaki
Preamplifier.
PHONO LOAD ADJUSTMENT
The phono stage load can also be adjusted to suit your phono turntable
specifications (47k ohms is the factory setting). Disconnect the lead from the IEC
socket on your Kaitaki Preamplifier and make sure the Mains switch is OFF. Carefully
remove the lid by undoing the cap screws on the top and side. Locate the ‘piano’
switches at the back of the phono circuit board. The load can now be adjusted
following the labels in front of the load switches. Be sure to adjust both the left
channel (lower) and right channel (upper) switch to the same value. Now re-assemble
your Kaitaki Preamplifier.