Plinius KAITAKI, Инструкция по эксплуатации

Страница: 13 / 22

11 PREAMPLIFIER
Remote Control Functions
The Plinius Kaitaki Preamplifier features a full function remote to control all settings
and configurations of the preamplifier as well as complete controls for operating your
Plinius CD player.
KAITAKI PREAMPLIFIER REMOTE FUNCTIONS:
1. STANDBY
Standby is used to put the unit into a low power mode. This
disconnects the outputs of the preamplifier and turns off the white
display LED’s. It also switches the preamplifier to a low bias mode
to reduce power consumption and still keep the circuitry active.
This allows a minimum warm up period before the Plinius Kaitaki
Preamplifier is at it’s sonic best.
2. DISPLAY
The display button on the remote enables you to adjust the
display brightness of the white LED’s. Pressing the display button
repeatedly will dim the LED in steps until they are off. The next
press of the button will cycle the display back to full brightness.
3. SOURCE SELECTION
The source selection buttons enable changing from one input to
another when needed and can be scrolled left or right to select the
desired source. On reaching the left most or right most input, the
selection will scroll in a continuous loop with the next button press.
4. HT BYPASS
The HT Bypass button activates the Plinius Kaitaki Preamplifier
home theatre bypass mode. Once activated, the preamplifier
is bypassed and the signal is transmitted from the HT Bypass
input directly to the output. NOTE: In HT Bypass mode the only
buttons that continue to function are Standby and Display. More
information on HT Bypass can be found in the Installation &
Operation section in this manual.
5. PHASE
The phase of the output signal from the preamplifier is toggled from absolute (in-
phase) to inverted 180 degrees with each press of this button.
6. VOLUME CONTROL
Use these two buttons to control the volume level of the preamplifier. The right side
2
7
10
11
1
6
3
4 5
8
12
9
13