Section 5. Maintenance and Troubleshooting
30
PlexWriter 8/4/32 Operation Manual
2.
Double-click the CD-ROM icon and choose the PX-W8432T by clicking on it
once. Then, click on the Properties button and select the Settings tab. You now
see the drive properties for the PlexWriter.
3.
Enable DMA by click the DMA checkbox ON, then click OK.
Disable DMA by click the DMA checkbox OFF, then click OK.
4.
Close the System Properties window by clicking on the Close button.
5.
When prompted, Reboot your system.
Note:
DMA must be enabled for normal operation of the PlexWriter.
Troubleshooting
If you have problems during or right after installation of your PlexWriter drive, use
these tips to help find the problem. You can also use these charts to help find
problems that develop in existing installations.
Start here if you're a PC user. Mac users should start with page 39 and come back
here if they don't find the answer.
Troubleshooting: General
Symptoms
PlexWriter drive not recognized by computer.
Possible Cause #1
•
IDE cable is not connected properly.
Solution #1
•
Ensure IDE cable is connected.
•
Verify that connectors on motherboard and drive do not have bent pins.
Possible Cause #2
•
Drive or IDE bus is not enabled in the computer’s BIOS.
Solution #2
•
Ensure the IDE port is enabled and set properly in motherboard’s BIOS.
See “Make Sure the Drive Is Recognized” on page 17 for more details.
Possible Cause #3
•
Jumper conflict.
Solution #3
•
Check jumpers for the PlexWriter drive and the other peripheral devices (hard
disk or CD-ROM drive) on the same IDE cable. Ensure the jumper for one device
is set to master and the other to slave. Two devices on one cable cannot be set to
the same setting.
