Plextor PlexWriter 40/12/40A, Инструкция по установке и эксплуатации

Страница: 25 / 56

Section 2. Installing Your PlexWriter
PlexWriter 40/12/40A Installation and Users Manual
19
8. Double-check your work. You must ensure the side of the IDE cable with the red
stripe is matched to Pin 1 on the interface board and on the drive.
CAUTION: In the case of only one IDE device, you must make certain that one
end of the cable is always connected to the IDE connector on the motherboard.
The other end of the connector must be connected to a device. The end
connector of the cable should never be left unconnected.
9. Connect a power cable from the computer to the DC INPUT connector of the
PlexWriter drive. In most computers, you will find free power connectors that are
ready for your use.
Check the cable running from your power supply to your hard disk and see if it
has extra connectors on it. If so, you can plug one of these into the power
connector found on the rear panel of the PlexWriter.
Figure 16: Cable Connections for an Internal IDE PlexWriter Drive
10. Connect the analog audio cable if you want to use a sound board in your system.
This cable runs from the four-pin analog audio output connector on the rear panel
of your PlexWriter drive to your sound board. See “Using Sound Boards and
Audio Cables” below for more information about audio cables.