Plextor PlexWriter 40/12/40A, Инструкция по установке и эксплуатации

Страница: 19 / 56

Section 2. Installing Your PlexWriter
PlexWriter 40/12/40A Installation and Users Manual
13
Before PlexWriter Installation How to Install the PlexWriter
D System uses special Cable Select
cables; all devices are jumpered for
Cable Select.
Set the PlexWriter’s mode jumper to
CSEL, and connect it to the end of
the cable from the computer’s IDE
interface connector.
Figure 9: How to Install the PlexWriter If Your Computer Is Originally Set Up in
Configuration D
About Cable Select
The Cable Select jumper position sets the PlexWriter drive to use the CSEL signal
from the IDE interface for configuration purposes. This signal automatically selects
the correct Master/Slave setting for the PlexWriter. To use CSEL, you must have:
•
A computer that supports CSEL.
•
A special CSEL cable for IDE.
Figure 10: Using the CSEL Signal to Configure the PlexWriter Drive