pleasant hearth VFL-CO18DT, Руководство пользователя

Страница: 22 / 33

21
ASSEMBLING LOGS
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
CAUTION:
After installation and peridically thereafter, check to ensure that no yellow flame comes in
contact with any log. With the heater set to High, check to see if yellow flames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow flames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with heater. Each log is marked with a
number, and this number will help you identify
each log during installation.
Provided Logs: 6
Fig. 19 - Installing Log #1 Fig. 20 - Installing Log #2 Fig. 21 - Installing Log #3
1. Insert log #1 onto pins in
rear grate base.
2. Insert log #2 onto pins in
middle grate base.
3. Place log #3 onto the
front grate. Make sure the
recessed areas on the log
match up with the grate,
and the log is centered on
grate.
Fig. 22 - Installing Log #4 Fig. 23 - Installing Log #5 Fig. 24 - Installing Log #6
4. Place log #4 so it is rest-
ing in the top left recessed
areas of logs #1, #2, #3.
5. Place log #5 so it is
resting in the top middle
recessed areas of logs #1,
#2 only (it should NOT be
touching log #3), and the
front edge does not over
hang log #2.
6. Place log #5 so it is
resting in the top right
recessed areas of logs #1,
#2, #3
1 2 3
4 5
6
1 2 3 4 5 6