PlayMechanix Terminator Salvation Super Deluxe, Руководство по установке и эксплуатации

Страница: 13 / 56

Service Manual Setup and Assembly
Attach Rear Screen Frame Assembly to Screen Base
USES HARDWARE KIT B
1. Align holes at bottom of rear screen frame assembly posts with holes in rear of screen base.
The perpendicular flaps on the rear screen frame assembly should be very near the cross joiners.
See Figure 5.
2. Affix two

bolts through each post into the screen base. Do not tighten bolts.
3. Align hole on left cross joiner with hole on “A” corner bracket on rear screen frame.
4. Insert

bolt through flap into cross joiner. Do not tighten.
5. Repeat steps 3-4 through “B” corner bracket.
6. Tighten all bolts.
Figure 5: Screen Base Assembly with Rear Screen Assembly
Image is oriented from the rear with an access panel removed.
Attach Lower Screen Spacer to Frame Assembly
USES HARDWARE KIT C
1. Lift the lower screen spacer panel sub-assembly into place. Z-brackets should rest on bottom of
front screen assembly.
2. Tighten down z-brackets on spacer panel.
3. Position lower right snap bracket on top of spacer panel.
4. Affix five

screws through snap bracket into spacer panel. Do not tighten.
5. Insure snaps form a straight line and tighten all bolts and screws.
Figure 6: Lower Screen Spacer
Image is oriented from the rear. Snap bracket shown is on the left.
Terminator Salvation™ Copyright © 2010 T Asset Acquisition Company, LLC Page 13