Plasson PFS Monomatic, Инструкция по эксплуатации

Страница: 56 / 68

56 EN001 H01
12.6.12 Code Sys.
If this option is activated, the system configuration can only be accessed after entering an unlocking- resp.
supervisorcode. If this option is deactivated, each user can change the system configuration. By activating
this option, only users with the respective access level can change the system configuration.
Attention!
This option can be preset, depending on the device type. Contact your retailer or the manufacturer
of the electrofusion control unit before activating this option.
In any case you will need an unlocking- or supervisor code for accessing the system configuration if
this option is activated.
Step Action
1 Accessing the "Code Sys." option
1.1
Select the entry "Code Sys" in the system configuration, using the ▲
-
and ▼
-buttons.
2 Changing the "Code Sys." option
2.1
The ◄ ► buttons are used to move the marking (*) from the "activated" (+) column to the
„deactivated“ (-) column and vice versa.
2.2 After having this option changed in the system configuration press the green start button to accept
the change and acknowledge the following safety prompt "Are you sure?"by again pressing the
green start button.
You can abort the input by pressing the red stop button.
3 Prompt for the unlocking- resp. supervisor code
If the option "Code Sys." is activated, the following prompt will appear when trying to access the
system configuration. Enter an unlocking- resp. supervisor code here to gain access to the system
configuration.
Prompt for the unlocking- resp. supervisor code
3.1
Read in the unlocking- resp. supervisor code using the reading pen/scanner or press the enter
button to do the input by using the letter field. If you use the letter field, press the green start
button after the input to confirm the entered code.
Attention!
If "Code Lock" and "Code Sys." are active and "Code Sys." is deactivated, "Code Man.", "Code
Del." and "Secure data" will be deactivated automatically as well.
This shall show the user that by deactivating "Code Sys." there will be no sufficient safeguard
against manipulation anymore. Without the prompt for the unlocking- resp. supervisor code before
getting access to the system configuration the locking functions can easily be deactivated by any
user.
Operatorcode
50 Hz 230 V +23°C